Pulsafeeder J63115 Chem-Tech XPV Series Variable Speed Fuse Kit

The Pulsafeeder J63115 is a variable speed fuse kit for compatible Chem-Tech XPV Series chemical metering pumps. The manufacturer parts catalog identifies this product as Fuse Kit, Variable Speed, while replacement parts distributors list it as FUSE KIT, XPV.

This kit is intended for maintenance of the electrical protection arrangement used in applicable Chem-Tech XPV pump configurations. It is a replacement fuse kit rather than a complete variable-speed motor, control board or power supply assembly.

Product Specifications

• Manufacturer: Pulsafeeder
• Part Number: J63115
• Product Name: Chem-Tech XPV Variable Speed Fuse Kit
• Manufacturer Description: Fuse Kit, Variable Speed
• Distributor Description: FUSE KIT, XPV
• Product Type: Electrical Fuse Replacement Kit
• Product Family: Chem-Tech
• Documented Pump Series: XPV
• Application: Variable-Speed Pump Electrical System
• Component Category: Electrical Protection Components
• Fuse Current Rating: Manufacturer Verification Required
• Fuse Voltage Rating: Manufacturer Verification Required
• Fuse Type: Manufacturer Verification Required
• Fuse Dimensions: Not Independently Verified
• Kit Quantity: Not Independently Verified
• Exact Pump Model Compatibility: Verify Original Equipment Documentation

Chem-Tech XPV Variable Speed Fuse Kit

The J63115 fuse kit is listed specifically for the variable-speed electrical arrangement used in the Chem-Tech XPV pump family.

Electrical fuses are protective devices designed to interrupt current when their specified operating limits are exceeded. The exact protection characteristics depend on the fuse type and rating selected by the equipment manufacturer.

Using the correct manufacturer-specified replacement is important for preserving the intended electrical protection configuration.

Documented XPV Series Application

Pulsafeeder lists J63115 within the XPV Series Parts section of its metering pump catalog.

The same catalog section includes variable-speed drive motors, digital control boards, power supplies and motor control boards as separate replacement components.

J63115 should not be confused with these electronic assemblies. It is identified specifically as a fuse kit.

Electrical Protection and Fuse Selection

Fuse selection must follow the original equipment electrical specifications. Important parameters include rated current, rated voltage, interrupting capacity, physical dimensions and fuse operating characteristics.

The available catalog description does not establish these values for J63115. Confirm the correct fuse specifications using the applicable Chem-Tech XPV service documentation or Pulsafeeder technical support.

Never substitute a fuse with a higher current rating or an unverified electrical specification.

Potential Applications

• Chem-Tech XPV Series metering pump maintenance
• Replacement of manufacturer-specified variable-speed fuses
• Electrical control system servicing
• Industrial chemical dosing equipment maintenance
• Water treatment chemical feed pump repairs
• Original equipment electrical component replacement
• Preventive maintenance of compatible pump electrical assemblies

Inspection and Troubleshooting

Before replacing a failed fuse, determine whether an electrical fault, wiring problem or component failure caused the original fuse to open.

Inspect the fuse holder and related electrical connections for overheating, corrosion, loose contacts and visible damage.

Repeated fuse failure may indicate an underlying electrical problem requiring qualified technical inspection.

Installation and Safety

Before servicing the Pulsafeeder J63115 fuse kit, disconnect the equipment from its electrical supply and follow appropriate lockout and isolation procedures.

Electrical maintenance should be performed by qualified personnel according to the manufacturer service instructions.

Install only the specified fuse components and verify the electrical system is safe before restoring power.

Ordering Information

Order using the exact manufacturer part number J63115.

Confirm the pump model, XPV control configuration and manufacturer-specified fuse ratings before purchasing or installing the replacement kit.