Pulsafeeder 42729 Thread Mount Drum Mixer, 1/3 HP, 115/230V, 36-Inch 316 SS Shaft

Pulsafeeder 42729: Thread Mount Drum Mixer with 1/3 HP Motor

The Pulsafeeder 42729 is a thread mount mixer, model code T-2-O-H, that screws directly into a standard drum bung for vertical mixing. It pairs a 1/3 HP, 1725 rpm, 115/230 VAC motor with a 36-inch 316 stainless steel shaft and a 4-blade impeller that fits through the bung opening.

Technical Specifications

• Manufacturer: Pulsafeeder
• Part Number: 42729
• Model Code: T-2-O-H
• Product Type: Thread Mount Mixer
• Mounting: 2-Inch Nipple, Screws into Standard Bung
• Mixer Position: Vertical
• Motor Power: 1/3 HP
• Motor Speed: 1725 RPM
• Electrical: 115/230 VAC, 60 Hz
• Motor Type: Open Drip Proof, Split Phase, Sleeve Bearings
• Shaft: 36-Inch, 316 Stainless Steel
• Impeller: Single 4-Blade, 316 Stainless Steel

Direct Bung Mounting

The thread mount adapter has a 2-inch nipple that screws into a standard drum or tank bung, so no brackets or clamps are needed. The iron adapter has a corrosion-resistant coating.

Impeller Fits Through the Bung

The 4-blade 316 stainless steel impeller is sized to pass through the bung opening, allowing installation in closed drums.

Dual-Voltage Motor

The 1/3 HP open drip proof motor runs at 1725 rpm on 115 or 230 VAC, 60 Hz. As an open motor, it should be protected from splashing and wet environments.

Material Compatibility

Epoxy and vinyl shaft coatings are available on other models for solutions incompatible with 316 stainless steel. Verify compatibility before use.

Installation Guidance

Ensure the mixer location allows sufficient clearance between the impeller and tank walls. Disconnect power before installation or service.

Ordering Information

Specify Pulsafeeder 42729 for the T-2-O-H thread mount mixer with 1/3 HP 115/230V motor and 36-inch 316 stainless steel shaft.