Pulsafeeder K7WTSK PULSAtron KOPkit Repair Kit
Pulsafeeder K7WTSK PULSAtron KOPkit with PVC head and fittings, PTFE sealing components, 316 stainless steel valve balls and 3/4-inch OD tubing connection.
The Pulsafeeder K7WTSK is a genuine PULSAtron KOPkit (Keep-On-Pumping kit) designed to replace commonly serviced liquid-end components in compatible PULSAtron chemical metering pumps. KOPkits provide the primary replacement parts needed for preventive maintenance and liquid-end rebuilding.
The K7WTSK configuration features a PVC pump head and fittings, TFE/PTFE sealing components, 316 stainless steel valve balls and a PTFE-faced CSPE-backed diaphragm. The liquid-end configuration uses a 3/4-inch OD tubing connection.
K7WTSK Material Configuration
- Manufacturer: Pulsafeeder
- Part Number: K7WTSK
- Product Type: PULSAtron KOPkit / Liquid-End Repair Kit
- Pump Head / Fittings: PVC
- Seats / O-Rings: TFE / PTFE
- Valve Balls: 316 Stainless Steel
- Diaphragm: PTFE-faced CSPE-backed
- Connection: 3/4-inch OD tubing
Typical KOPkit Components
PULSAtron KOPkits are designed to replace components that normally experience wear during pump operation. Depending on the applicable pump configuration, the kit contains the liquid-end components required for routine service.
- Pump head assembly
- Suction valve assembly
- Discharge valve assembly
- Diaphragm
- Pump head screws and washers
- Deflection plate
- Shims
- Secondary seal
- Installation or assembly documentation
Preventive Maintenance for PULSAtron Pumps
The K7WTSK KOPkit provides a convenient way to service compatible PULSAtron metering pumps without sourcing common liquid-end replacement components individually. Periodic replacement of worn diaphragms, valve assemblies and sealing components can help maintain dependable chemical feed performance and reduce unplanned downtime.
Always confirm K7WTSK against the KOPkit number shown on the pump nameplate or specification documentation before ordering or installing the replacement kit.
